A supplier’s analysis sheet is the quickest way to judge whether a feldspar suits your body. Here is how to read one, using our own laboratory results as the example.
What the sheet shows
A whole-rock analysis reports each element as its oxide, in percent by weight. The main oxides add up to roughly 100%. Three extra rows are worth knowing:
- DL (detection limit): the lowest value the lab can measure reliably.
- “<0.01”: the oxide is below the detection limit, which in practice means it is negligible.
- LOI (loss on ignition): the weight lost on heating, from water, carbonates or organic matter. Low LOI means less gas is released during firing.
The four numbers that matter most
1. Na₂O and K₂O: fluxing power
These alkalis decide how strongly the feldspar fluxes. For a sodium feldspar, look at Na₂O first. Pure albite contains about 11.8% Na₂O, so a rough estimate of the albite share is Na₂O ÷ 11.8.
2. Al₂O₃: feldspar content and strength
Alumina usually rises together with Na₂O, because both come from the feldspar mineral itself.
3. Fe₂O₃ and TiO₂: fired colour
These are the colouring oxides. For light-coloured or white bodies, buyers set a maximum for each.
4. SiO₂: free quartz
Silica above what the feldspar itself contains points to free quartz. That is not necessarily a problem, because quartz is part of most tile body recipes anyway.
Worked example: our three grades
| Code | Na₂O | Al₂O₃ | SiO₂ | Fe₂O₃ | TiO₂ | LOI | ≈ albite* |
|---|---|---|---|---|---|---|---|
| 05 | 10.04 | 18.64 | 66.85 | 0.89 | 0.60 | 1.26 | ~85% |
| 03 | 7.04 | 14.41 | 76.25 | 0.53 | 0.06 | 0.48 | ~60% |
| 04 | 6.57 | 12.54 | 79.21 | 0.49 | 0.05 | 0.45 | ~56% |
* A rough estimate (Na₂O ÷ 11.8). It is useful for comparing grades, not a mineralogical measurement.
- Code 05 is the strongest flux, with the highest Na₂O and Al₂O₃. It also has the most iron and titanium of the three.
- Codes 03 and 04 contain more free quartz, with very low Fe₂O₃ and TiO₂ and low LOI.
Quick checklist
- Is Na₂O (+K₂O) high enough for the fluxing your body needs?
- Are Fe₂O₃ and TiO₂ within your colour limits?
- Is LOI low?
- Do the analysis date and method appear on the sheet?