Feldspar is the flux in a tile body. During firing it melts, holds the body together and closes up its pores. Sodium feldspar does this job well and at a relatively low temperature.
What is sodium feldspar?
Sodium feldspar is a natural aluminosilicate mineral, mainly albite (NaAlSi₃O₈). Pure albite contains about 11.8% Na₂O, 19.4% Al₂O₃ and 68.7% SiO₂. Natural deposits always contain some quartz and other minerals, so commercial grades come in a range of sodium contents.
Its role during firing
A typical tile body is a mix of clays, quartz and feldspar. Clay makes the body plastic and gives it strength before firing. Quartz forms the skeleton. Feldspar is the flux, and as the kiln heats up it:
- melts and forms a glassy phase that bonds the clay and quartz particles together,
- fills the pores, which lowers water absorption and raises mechanical strength,
- lets the body vitrify at an economical firing temperature.
In porcelain and vitrified tiles, where very low water absorption is the target, feldspar usually makes up a large share of the recipe.
Sodium or potassium feldspar?
| Sodium feldspar (albite) | Potassium feldspar (orthoclase) | |
|---|---|---|
| Melting behaviour | Melts at a lower temperature; the melt is more fluid | Melts more gradually; the melt is more viscous |
| Effect on the body | Strong, fast fluxing and good densification | A wider firing range and better shape stability |
| Typical use | Fast-fired tile bodies | Bodies that need a wide firing window |
Many plants blend the two. The right ratio depends on the kiln cycle, the clays you use and the product you make.
Which oxides to watch
- Na₂O (+ K₂O): the alkalis that do the fluxing. Higher values mean a stronger flux.
- Al₂O₃: a sign of feldspar content. Alumina also adds strength and stability.
- Fe₂O₃ and TiO₂: colouring oxides. The lower they are, the lighter and whiter the fired body.
- SiO₂: a high value usually means free quartz is present alongside the feldspar.
Why lumps?
Tile plants normally grind their raw materials together in ball mills, so feldspar supplied as lumps (in our case 0–50 cm) goes straight into the plant’s own preparation line. This keeps handling simple and the cost per tonne low.